Eigenschaften
Returns the Engine object. | ||
Sets image type (black-and-white, gray, color). The default value of this property depends on the scanner. | ||
Specifies the type of compression to be used for the scanned images. Please note that the possible type of compression depends on the image’s colority. The default value of this property depends on the scanner. | ||
Specifies the brightness of the scanned image (0-100). It is only valid when the BrightnessControl property is set to SBC_Manual. The default value of this property depends on the scanner. | ||
Sets brightness control mode. The default value of this property depends on the scanner. | ||
Gibt die Bildauflösung an. Diese Eigenschaft kann einen beliebigen Wert im Bereich von 100 bis 1200 annehmen. Für optimale Erkennungsergebnisse empfehlen wir jedoch, die Bildauflösung auf einen durch 100 teilbaren Wert im Bereich von 200 bis 600 festzulegen. Der Standardwert dieser Eigenschaft hängt vom Scanner ab. | ||
Sets image rotation angle (once the image has been scanned). The default value of this property depends on the scanner. | ||
Sets paper size. The default value of this property depends on the scanner. | ||
Sets the coordinate of the bottom border of the scanning area rectangle (in milli-inch). It is only valid if PaperSize = SPS_Custom. By default, this property is set to 0. | ||
Sets the coordinate of the left border of the scanning area rectangle (in milli-inch). It is only valid if PaperSize = SPS_Custom. By default, this property is set to 0. | ||
Sets the coordinate of the right border of the scanning area rectangle (in milli-inch). It is only valid if PaperSize = SPS_Custom. By default, this property is set to 0. | ||
Sets the coordinate of the top border of the scanning area rectangle (in milli-inch). It is only valid if PaperSize = SPS_Custom. By default, this property is set to 0. | ||
Gibt an, ob das mehrseitige Scannen aktiviert ist. Standardmäßig ist diese Eigenschaft auf FALSE gesetzt. Wenn die Scan-Optionen im FineReader Engine-Dialogfeld so konfiguriert sind, dass der
automatische Einzug verwendet wird, wird der Wert dieser Eigenschaft ignoriert und das
mehrseitige Scannen aktiviert. Der Grund dafür ist, dass der automatische Einzug für das
mehrseitige Scannen vorgesehen ist. | ||
Sets the required delay between scanned pages (no pause, delay for specified number of seconds, prompt for next page). By default, this property is equal to SPM_None. | ||
Sets the pause between pages in sec. It is only valid if PauseBetweenPagesMode = SPM_PresetDelay. Some scanners with automatic document feeder may ignore the value of
this property. By default, this property is 0. | ||
Specifies whether an automatic document feeder must be used. The default value of this property depends on the scanner: if the scanner has a flatbed, it is equal to SPFM_Flatbed. If not, it is SPFM_AutoFeeder. | ||
Specifies whether duplex scanning must be used. If DuplexMode is set to TRUE you must also set MultipleImagesEnabled
to TRUE. By default, this property is set to FALSE. | ||
Setting this property to TRUE enables automatic skew correction, if this feature is supported by the scan source (seeScanSourceCapabilities::CorrectSkewSupported). By default, this property is set to FALSE. | ||
Setting this property to TRUE enables automatic removal of blank pages, if this feature is supported by the scan source (seeScanSourceCapabilities::DiscardBlankPagesSupported). By default, this property is set to FALSE. | ||
Objektdiagramm